RM Stator Pickup Pulsar Coil 200 ohms for Honda TRX 680 Rincon 2006-2014

Brand new pick up coil 200 ohms

• We offer a brand new pickup/pulser coil for you to repair your stator.
• Often unavailable from the OEM manufacturer
• All products shipped are tested

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Specifications

Dimensions:
Height: 18 mm
Length: 25 mm
Width: 22 mm

Bracket center to center: 35 mm

Wires length: 325

Other specifications:
Number of wires: 2
Number of pins: 2

Wire to wire resistance: Blue to Green = 200 ohms +/-20%

Interchange Part Nº

• 31120-HN8-A60
• 31120-HN8-A61
• 31120-HN8-A62

Installation

Not following these instructions may result in damaging the part or other components on your vehicle.

• By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
• Insulate your solders with heat shrink.
• Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
• Rotate the flywheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010’’.
• If no spark or erratic spark, switch the wires at the plug.

Warning:

Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.